Wet room shower tray with linear corner drain

This tileable floor element from Saxoboard® is a substructure element for installing level-access showers. The board is made of expanded polystyrene, a rigid foam, and is suitable for flush installation in the screed. This installation method, combined with the use of high-quality materials, not only creates an exceptional shower experience, but also makes it possible to use the level-access shower with a wheelchair.

Your advantages at a glance

• 100% watertight at the factory + ready to install
• Slope already integrated
• incl. drain + stainless steel grate
• Directly from the manufacturer
• Barrier-free installation

Drain design

In order to fulfil your desire for a customised shower solution, we offer you a choice of four different designer gratings. Whether you opt for the Bubble, Line, Pyra or Quadro design, you can add a personal touch with your choice.

Freedom when installing the shower and the drain position

We supply the flush-to-floor Saxoboard® shower element with channel corner drain with drain, odour trap and a stainless steel grate to cover the drainage system. The drain can be installed vertically or horizontally. The horizontal drain can be set to any drainage direction at the installation location. The drain is easy to clean. The overall installation height varies between 40 mm with a vertical outlet and 105 or 125 mm when installing a horizontal outlet. In the corner area, we allow the applied sealing fleece to protrude by 7 cm on two sides. This allows you to easily seal the corner area by simply sticking the overhang up the wall (or floor).
Mineral surface can be selected for even higher point loads.

100% impermeability at the edge

With this option, we leave a 7 cm overhang around the edge of the shower element with the sealing fleece applied. This overhang is simply glued up the wall and over the neighbouring floor. This allows you to achieve 100% impermeability in the edge area, because the shower element acts like a closed tray!

• Sound insulation certificate in accordance with DIN 4109
• System tested in accordance with DIN 18534-5
  (all components of the system tested)

Please note: The position of the drain should always be seen as if you were standing in front of the dimensionally short side.

SaxoPET Eco

You have a choice of three different substrate materials. All are highly pressure-resistant. SaxoPET Eco is the world's first sustainable substrate material for showers that is made from 100% recycled PET and is also highly pressure-resistant (pressure resistance 110 tonnes/m²).

Fully integrated electric or hot water underfloor heating (optional)

No more standing with your feet on a cold shower floor in the morning. That's the promise of our elements with fully integrated electric underfloor heating, which can be installed at the factory on request. Only the connection cables then protrude from the shower element, which only need to be connected to the existing power supply. If you would like hot water heating for our shower elements, please send us your existing underfloor heating pipe. We will then integrate this completely into the shower element. The connections for this look out at the points you specify (these are configured above). The heating integrated into the shower element does not increase the installation height/thickness of the shower element.