Wet room shower tray made of PET with linear drain EasyFlex cuttable

This short tileable floor element from Saxoboard® is a substructure element for installing level-access showers. The shower board is made of high-pressure resistant PET material with 150 kg/m³ - a hard foam - and is suitable for flush installation in the screed, but also for installation directly on the floor.

Your advantages at a glance

• 100% watertight at the factory + ready to install
• Channel can be shortened from 120 to 30 cm
• Slope already integrated
• incl. drain + top section
• more favourable due to direct sales from the manufacturer
• Barrier-free installation

This installation method in combination with high-quality materials not only creates an exceptional shower experience, but also makes it possible to use the level-access shower with a wheelchair. The surface of the shower board with channel is either our sealing fleece or a mineral coating for an even higher point load. Our shower elements with channel are tested and approved by the building authorities.

Our shower channel installed in the shower board is made entirely of full stainless steel and is height-adjustable from 1 mm to 20 mm. A stainless steel channel base is installed in the shower element at the factory. This represents the second drainage level, allowing the water to continue to run into the trap even if the board is damaged.
The shower channel itself can be shortened up to 30 cm.

Drain position within the channel

The drain position is in the centre of the channel.

100% tightness at the edge

With this option, we leave a 7 cm overhang around the edge of the shower element with the sealing fleece applied. This overhang is simply glued up the wall and over the neighbouring floor. This allows you to achieve 100% impermeability in the edge area, because the shower element acts like a closed tray!

• Sound insulation certificate in accordance with DIN 4109
• System tested in accordance with DIN 18534-5
  (all components of the system tested)

Freedom when installing the shower and the drain position

We supply the flush-to-floor Saxoboard® shower element with channel with drain, odour trap and a stainless steel grate to cover the drainage system. The drain can be installed vertically or horizontally. The horizontal drain can be set to any drainage direction at the installation location. The total installation height varies between 30 mm with a vertical outlet and 125 mm when installing a horizontal outlet.

SaxoPET Eco

The shower element is made of a PET rigid foam material. SaxoPET Eco is the world's first sustainable substrate material for showers that is made from 100% recycled PET and at the same time has maximum compressive strength (compressive strength 110 tonnes/m²).

Fully integrated electric or hot water underfloor heating (optional)

No more standing with your feet on a cold shower floor in the morning. That's the promise of our elements with fully integrated electric underfloor heating, which can be installed at the factory on request. Only the connection cables then protrude from the shower element, which only need to be connected to the existing power supply. If you would like hot water heating for our shower elements, please send us your existing underfloor heating pipe. We will then integrate this completely into the shower element. The connections for this look out at the points you specify (these are configured above). The heating integrated into the shower element does not increase the installation height/thickness of the shower element.